davegee Posted May 14, 2014 Report Share Posted May 14, 2014 I add an image to the slide list.Later I decide to edit the image in my RAW Converter and make a substantial change to the image.I save the Image to my original Project folder and run the sequence.The changes to the Image are recognised by the Preview and in a Published EXE but in the Slide List the original un-edited image is shown until I close PTE and re-open the Project.I seem to remember that this "problem" occured before - was it not cured or has it cropped up again?DG Quote Link to comment Share on other sites More sharing options...
PGA Posted May 14, 2014 Report Share Posted May 14, 2014 Dave,You might find that all you need to do is step left or right to the adjacent slide in the Slide List - and then back again. Last time I did a Ctrl+W to make a minor change to an image, that was what I had to do to get the thumbnail refreshed.regards,Peter Quote Link to comment Share on other sites More sharing options...
davegee Posted May 14, 2014 Author Report Share Posted May 14, 2014 No, I tried stepping back and forth - no go!I'll try Ctrl+W next time.DG Quote Link to comment Share on other sites More sharing options...
Barry Beckham Posted May 15, 2014 Report Share Posted May 15, 2014 I don't think it has been addressed and at one time it would do the same with music if you went outside PTE (prior to V8) and saved a sound file over the original. I started to get into the habit of changing names, or closing PTE and reopening it.You have to force it to refresh, which can be a nuisance, but probably more confusing for a new user Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.