Jump to content
WnSoft Forums

Don't Disable 'Convert' After Video Has Been Converted


Recommended Posts

Greetings,

After a video clip has been Converted, that video clip can not be re-converted (with the same set of criteria) without importing it again and resetting the criteria from scratch. Perhaps, the word 'Disable' is not correct but I can not come up with a better term. You have to remove that clip and re-start the Convert process for that video clip.

This can be a problem if you have set specific trim points, quality and resize choices and want to just tweak these choices from what you had just converted. If you convert a clip and then see that you want to make some adjustments in trim points, quality or resize choices, you have to start all over again from scratch, resetting all the previously set criteria.

Sure, you can write down all the criteria and reset it. But, instead of having to remove the converted clip and start over again from scratch, it would be very helpful to just be able to make adjustment to the already set criteria and re-convert.

Gary

Link to comment
Share on other sites

Gary,

We plan to fully rewrite Video convertor in PTE. I hope that it will be done in the next v10.0. This part of PTE should vastly reworked to make it more user friendly and support more video formats + solve known technical issues.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...